Atop-technology EH7510 User manual Manual de usuario descargar pdf (Pagina 34)

Atop Industrial Managed Ethernet Switch

EH7510

User Manual V 1.0

2.4.3 Port Control

Port settings are included to give users control over State (enabled or disabled), Port

Transmission Speed, Duplex, Flow Control, Rate Control and Throughput Test.

Fig. 2.23

Table 2.12

Label

Description

Factory Default

Port

Port number on the switch.

Enable

Check the box to allow data to be transmitted and

received through this port.

All ports are enabled

Negoti

ation

Choose from Force or Auto. See notes below.

All ports Auto- Negotiation

is enabled.

Speed

Select either 10, 100,1000(Port 9, 10 only) Mbps

Port1~Port8: 100Mbps.

Port9, Port10: 1000Mbps.

Duplex

Select either Half or Full Duplex. See note below.

All ports are Full-Duplex

mode.

Flow

Control

Either on or off “Flow Control” to avoid packet

loss when congestion occurs.

All ports flow control is

disabled.

Rate

Control

Sets limits on its transmission rate for the

incoming and outgoing. Unit: kbps

All ports rate control is

disabled.

Throughput

Test

Click button to start test ingress and

outgoing rate of this port.

Note: The maximum rate test is limited under

98Mbps.

*Note:

- Rate Control: Outgoing and incoming values have to be set between 0 and 102400(for

100M) or 1024000(for 1000M)..

0 is to turn off rate control.

The values have to be integer multiples of 64 when rate is less than 1792Kbps. Ex: 64k,

128k .. 512k…1792Kbps.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 119 120

Comentarios a estos manuales

Sin comentarios

Atop-technology EH7510 User manual Manual de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Atop-technology EH7510 User manual