Atop-technology MB5001C Quick Start Manual de usuario descargar pdf

Atop Technologies, Inc.

1-port Modbus Gateway

MB5001C/MB5001C-Sis

Quick Start Guide

Version 1.1

Updated on Sept. 14, 2010

Overview

Modbus is an industry adopted communication protocol

based on RTU, ASCII, and TCP protocols for various

applications; these three protocols are commonly used by

hardware equipment in the industry, such as DCS, PLC,

HMI, power load measurement, various sensor and

measuring instruments. The Modbus Gateway is capable

of implementing the Modbus environment between

different hardware interfaces, thereby streamlining the

process of management and application. For detailed

information and operations of the product, please refer to

the product user’s manual in the Product CD.

Packaging Included

 Atop MB5001C or MB5001C-Sis Modbus Gateway

 Wall mount kits x 2

 Quick Start Guide with Product Warranty Card

 Product CD (User’s Manual and Utility Software)

Hardware Setup

The following figure shows the components on the panel of

including both MB5001C and MB5001C-Sis models.

*Reset Button:

Press Reset button continuously over 3 sec to reload the

device to the factory default settings.

LED Indications

The LEDs indicate the status of MB5001C.

Please see the front panel

Name Color Status Description

Off Ethernet Disconnected

Green

Blinking

Data is transmitting on

Ethernet for 100Mbps

LAN

Orange Blinking

Data is transmitting on

Ethernet for 10Mbps

Off

No data is transmitting on

COM port

COM Green

Blinking

Data is transmitting on COM

port

Off System is not ready or halt

Jumper JP1 Pin1 and Pin2

are shorted to disable

AP firmware running

RUN Red

Blinking

AP firmware is running

normally

Hardware Installation

Step 1: Connect MB5001C to power source using 5V DC

Jack or 9-30V DC 3-pin Terminal Block.

Step 2: Connect MB5001C to Ethernet network.

Step 3: Connect MB5001C’s serial port to a serial device.

UL Notice for Power supplier

All the series of MB5001C products series are intended to

be supplied by a Listed Power Unit marked with “LPS”,

“Limited Power Source” or “Class 2” and output rate

9-30VDC, 1A minimum. Otherwise, use the recommended

power supply in “Optional Accessories.

1 2

Indice de contenidos

Pagina 1 - MB5001C/MB5001C-Sis

Atop Technologies, Inc. 1-port Modbus Gateway MB5001C/MB5001C-Sis Quick Start Guide Version 1.1 Updated on Sept. 14, 2010 Overview Modbus is an i

Pagina 2 - Warranty Policy

Network Configuration There are two steps to configure the device. First, you need to find the device in your network using our software tool, Device

Comentarios a estos manuales

Sin comentarios

Atop-technology MB5001C Quick Start Manual de usuario

Busca en linea o descarga Manual de usuario para Hardware De La Computadora Atop-technology MB5001C Quick Start. Atop Technology MB5001C Quick Start User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Atop-technology MB5001C Quick Start