
Atop Serial Device Server
SE5002D
User Manual V. 1.1
3.2.6 Configure SE5002D as a TCP Client
Fig. 3. 8
Type 2 in the “Input choice (1~5) and enter:”
Input destination IP in the “Please input Destination IP:”
Input destination port in the “Please input Destination port:”
Select TCP connection behavior: 1 for connect always, 2 for connect on serial data.
If “2” is selected, the console will prompt for additional configurations.
Input idle time to disconnect in the “Please input idle time to disconnect (0se,
1~255):” (Input 0 to disable; input 2 to disconnect TCP connection after 2 seconds
of serial inactivity).
Input error retrying time in “Please input waiting time for error retrying (0
minute, 1~255):” (input 0 to disable; input 2 to try to connect to a TCP Server every
2 minutes).
Input idle time in “Please input idle time to send TCP alive packet (x*10sec):” (input 2
to send TCP keep alive packet every 20 seconds).
Comentarios a estos manuales