
Atop Serial Device Server
SE5002D
User Manual V. 1.1
3.5.6 Multi-Point TCP Pair Connections
The difference between Multi-Point TCP Pair Connection and Multi-Point UDP Pair Connection
is that the TCP implementation would also exchange flow controls pins of RS-232. However,
the TCP Server is limited to a maximum of four connections. If there are than four serial
devices and does not use flow control pins of RS-232, it is possible to setup pair connection in
UDP mode, Sec. 3.6.3. After multi-connection is enabled in the WebUI, refer to the following
table to setup Pair Connection as in Fig. 3. 31.
Table 3. 2
Fig. 3. 31
Comentarios a estos manuales