Atop-technology SE5416A User manual Manual de usuario descargar pdf (Pagina 73)

Atop Industrial Serial Device Server

SE5408A/SE5416A Series

User Manual V 1.0

Figure 7.2

For setting as a TCP Server, please follow these steps.

 Click on the COMX link under Serial on the left hand side.

 Select TCP Server in the Link Modes; TCP Server is the default link mode. Also in this

section you will find the following options.

 Mode, there are 3 different communication modes here:

 RAW, there is no protocol on this mode, meaning the data is passed

transparently.

 Virtual COM, the Virtual COM protocol is enabled on the device to

communicate with a virtualized port from the client. It is possible to create a

Virtual COM port on Windows/Linux in order to communicate with the device

as a Client.

 Reverse Telnet, used to connect the device and another serial device

(usually a Terminal Server) with a Telnet program. Telnet programs in

Windows / Linux usually require special handshaking to get the outputs and

formatting show properly. The SE5416A Series will interact with those special

commands (CR/LF commands) once Reverse Telnet is enabled.

 Enter the Local Port, this option specifies the port number that the server should listen to;

it is used by the client to connect to the server. Default local port is 4660.

 Go to Response Behavior for more information on this setting. For serial settings, go to

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 112 113

Sin comentarios

Atop-technology SE5416A User manual Manual de usuario Pagina 73